|
No water |
The measuring contacts of the probe are not flooded. |
|
Water |
The measuring contacts of the probe are flooded. |
|
Not configured |
The sensor is not configured to your AP/router. |
|
Probe disconnected |
This announcement represents disconnection or interruption of the probe's cable. |
|
Check device |
This announcement means no message from the detector arrived to the cloud for a period over 9 hours.
This condition can be caused by the detector's malfunction, loss of connection between the detector and
AP (increase of signal attenuation for WiFi signal, AP power supply malfunction of interruption)
or interruption of AP connection to the Internet. |
|
Low batteries |
When the battery capacity drops below 20%, this symbol will be displayed and an announcement for battery replacement sent. |
|
On |
The contact of the appropriate input is closed. |
|
Off |
The contact of the appropriate input is open. |
|
TEMP HI |
HI Limit - Symbol for “upper limit is exceeded” - TEMP HI state |
|
TEMP LO |
LO Limit - Symbol for “lower limit is exceeded” – TEMP LO state |
|
TEMP OK |
When the temperature is between HI and LO limit |